I. Prepare stick
1st method for .tar.gz Image
Make 2 partitions on your USB Stick
1st 128MB FAT
2nd ext2 filesystem
at 1st partition copy uImage from /boot
at 2nd partition unpack all rootfs image such as /boot /var /etc /lib and others
rootfs must be unpack on Linux operating system
2nd method using .img HDClone Image
http://www.miray.de/...clone.html#free
Put USB stick in your PC USB port
Run HDClone4
Select Recovery .img Image to USB stick destination
II. Loader procedure
1. connect your octa1008+ with your PC by null modem cable
2. download and run putty
3. putty configuration:
- connection type Serial
- Serial line COM1 or COM2 or COMX (depend of your controller)
4. open connection
5. Switch OFF 1008+ then Switch ON and quickly press ENTER until uboot stop
6. If succeed unpack loader.zip and copy pktloader.bin on your USB stick in FAT partition
7. Put USB stick in your sf1008+ USB slot
8. write command below:
Kod: Zaznacz cały
usb reset
fatload usb 0:1 0xa80000000 pktloader.bin
protect off 1:3-3;erase 1:3-3;cp.b 0xa80000000 0xa0060000 $filesize;protect on 1:3-3
set bootcmd autoscr a0060000
save
After upgrade loader script sf1008+ is ready to running E2 automatically from USB stick or running original software when USB stick is out
below loader script is for 1.54 base loader
loader script for 6.2 base loader should be available soon